Is there a better or more efficient way to run user entries through multiple condition actions to verify if they are correct?

[MRodgers]

Hello, new here.

I have a series of 3 very short quizzes in a section. ( Each of the three sections has 3 questions each) so that would be a total of 9 questions all together.

All 3 sections logic will be run on the same workflow.

For example:

User answers Series 1:

Question 1

Question 2

Question 3

When the user Submits, it  goes through a workflow where three separate conditions check each of the answers to verify if they are correct. 
If Question 1 = "Red" AND "Series = "1" then value is correct.

If Question 2 = "Green" AND "Series = "1" then value is correct.

If Question 3 = "Blue" AND "Series = "1" then value is correct.
An email is then sent and it will state in succession each answer is either correct or not.

Using the same workflow :

Then Series 2 begins

and the same procedure above but this time 

If Question 1 = "3.14" AND "Series = "2" then value is correct.

and so on and again for the next 2 questions and finally the same for Series 3

Is there a way to make this more efficient rather than creating 9 separate conditions?
Or will using 9 separate conditions work just the same?

Any help would be greatly appreciated.

[AmeerJab]

Hello,

If the d for the first set of conditions you can use the trigger condition part in the settings of the trigger

it's syntax goes like this @And(equals(triggerOutputs()?['QuestionOne'],'red'),equals(triggerOutputs()?['Series '],'1')

you can add as much conditions as you want, always remember the @ at the start

[MRodgers]

Hello @AmeerJab , thank you for the reply. I can see how the trigger would be useful but I don't understand how I can use it to simplify using many conditions to verify if each set of questions are correct and let the user know by email.

For example:

First set of answers:
If fruit is equal to banana then in the email : banana is correct
If ball is equal to red then in the email : red is correct

If city is equal to Oslo then in the email : Oslo is correct

Then the user will answer another set of questions and the same flow will be used but another subset of conditions checking to see if these answers are correct.

And lastly, a last set of 3 questions also using the same foe to check of the answers are correct.

All answers will be the same for al 9 questions, meaning each set of 3 will have static answers to verify.

Thank you for any assistance.